The Toshiba TDP-T250 and TDP-TW300 projectors can be accessed though a local area network (LAN) connection, once the projector's IP address has been 'registered' with the computer. Both models can be accessed through a familiar wired Ethernet LAN connection. The model TDP-TW300 can also be accessed through a Wi-Fi (wireless Ethernet) LAN connection.

Follow the instructions in either section A1 or section A2 to determine a projector's IP address, and then follow the instructions in section B to register that address with a computer, using the Toshiba Projector Management Utility.

A1   Determining a projector's IP addresss through a wired Ethernet connection

A2  Determining a projector's IP addresss through a Wi-Fi wireless Ethernet connection

B    Registering the projector's IP address with a computer

A1: To determine a projector's IP address through a wired Ethernet connection, follow these steps:
      This method is suitable for models TDP-T250 and TDP-TW300 .

1. Connect the projector to an Ethernet LAN with a Category 5 (or higher) Ethernet cable.
   
   
2. If the projector is off, turn it ON.
   
   
3. Wait for the Toshiba logo to disappear, and then press the projector's Menu button.
   
   
4. Press the projector's right arrow key (Vol+) four times. The Status Display screen will appear.
   
   
5. The projector's IP address should be displayed under the heading "Wired LAN". Make a note of this IP address. Continue to section B of this bulletin.
   
   

A2: To determine a projector's IP address through a Wi-Fi wireless Ethernet connection, follow these steps:
      This method is suitable for the model TDP-TW300 projector.

1. Insert the Wireless LAN PC Card into the PC Card slot at the back of the projector. This card is supplied with the projector.
   
   [Before removing a PC Card from the projector -- while the projector is on or in the standby state -- be sure to press the Unmount button near the PC Card slot. Make sure that the Card light goes out before removing the PC Card.]
   
   
2. If the projector is off, turn it ON.
   
   
3. Verify that the projector is in Wi-Fi Infrastructure mode. Please see the projector's Owner's Manual for instructions.
   
   
4. Wait for the Toshiba logo to disappear, and then press the projector's Menu button twice.
   
   
5. Press the projector's right arrow key (Vol+) four times. The Status Display screen will appear.
   
   
6. The projector's IP address should be displayed. Make a note of this IP address. Continue to section B of this bulletin.
   
   

B: To register the projector's IP address with a computer, follow these steps:

1. Launch the Projector Management Utility on a computer. If there are no projectors registered with the Projector Management Utility, a dialog box will appear prompting you to "Register the projectors. Please refer to help for details." Click OK to continue.
   
   
2. Click the Edit tab, click the Register Projector button, and click the Specify IP Address tab.
   
   
3. Enter the projector's IP address, and click the Confirm button.
   
   
4. Enter the password for the projector, if a prompt appears (from PJ Link Authentication).
   
   If the Projector Management Utility can find the projector on the network, its name will appear beneath its IP address.
   
   
5. Click the Register button, click OK in the confirmation dialog box that follows, and click OK to close the Register Projector dialog box.

The projector is now registered for network access with the computer. Repeat the procedure to register additional projectors, or to register the same projector with other computers.

^{- mm/wa}