The Hibernation and Standby features are not supported in Windows 98
and 98SE on the Libretto 100CT.  We recommend that you disable the
Hibernate and Standby features by following this procedure:

1.   Click on Start and select Settings and click on Control Panel.
2.   Double click on the Power Management icon.  The Power Management
       Properties window will appear.
3.   Under the "Power Schemes" tab there is a section called
       "Settings for Portable/Laptop power scheme".  For "System
       Standby", change it to read "Never" for both "Plugged in"
       and "Running on batteries" and Click on "Apply".
       
       Note:  You will need to make these changes for all "Power
         schemes".  After changing these settings for each of the
         power schemes be sure to click on "Apply" for the changes
         to take affect.   
4.   Click on the tab labeled "Advanced".  In the section called
       "Power buttons" under "When I close the lid of my portable
       computer", change it to read "None" or Shutdown".  Under
       "When I press the power button on my computer" change it to
       read "Shutdown".
5.   Click on the tab labeled "Hibernate" and remove the check for
       "Enable hibernate support".
6.   Click on "Apply" for your changes to take affect and then click
       on "OK" to continue.  This will close the Power Properties
       window.
7.   In the Control Panel window, double click on the "Power Save"
       icon.  The Power Saver Properties window will appear.
8.   Under the "Power Save Modes" tab click on the "Details..."
       button.  This will open the setup window for the selected
       power mode. Click on the tab labeled "System".  Select "Boot
       Mode" and click on "Apply" then "OK" to continue. This will
       close the setup window for the selected power save mode.
       Click on "OK" to continue.  This will close the Power Saver
       Properties window.
       
       Note:  You will need to make these changes for both the
         "Battery Power" and "External Power" Power Settings and for
         each of the Power Save Modes you use.
9.    Restart your computer by clicking on Start, then select Shut
        Down.  Select "Restart" and click on "OK".
10.   The Hibernation and Standby features are now disabled.